股票配资世界歡迎您的到来!

新聞中心 News Center

聯系我們 Contact us

電話:+86 531 81253358
傳真:+86 531 81253375
Email:INFO@RNOMAC.COM
Website:www.yichunling.com
山東省濟南市槐蔭區美里湖美里路中段1929号

當前位置:首頁>新聞中心 > 産品知识 >

産品知识

擺線股票配资世界工作詳解

作者:瑞諾機械 時間:2016-08-23 17:09:00



山東瑞諾擺線股票配资世界工作原理
采用鑲柱式定轉子設計,具有更高的配油精度及機械效率。
雙滾动軸承設計,具有更大的側向承載能力。
可靠的軸密封設計,承受背壓高,可以串并聯使用。
正反轉換向方便、轉速平穩。
多種油口輸出軸法蘭等連接形式。
 
Characteristic features
It adapts the gerolor design, which has a higher distribution accuracy and Mechanical efficiency.
Double-rolling bearing design, which has a greater lateral load capacity.
Credible design of shaft seal, which can bear higher pressure and be used in parallel or in series.
Direction of shaft rotation and speed can be controlled easily and smoothly.
山東瑞諾擺線股票配资世界性能指數

1.最大工作壓力指入口最大壓力,額定壓力指工作壓差。

2.馬达不能同時在最大壓力和最高轉速下工作。
3.在斷續工作條件下,運行時間每分鐘不得超過10%。
4.推薦用68#抗磨液壓油,粘度37-73cSt,清潔度ISO18/13。
5.最高工作油溫80°。
6.馬达全負荷工作前,應在最高工作壓力的40%以下磨合1小時。
7.馬达允許最高背壓10MPa,但建議不要超過5MPa,超過 時應接外洩油管.
1. Intermittent means the entrance of the maximum pressure; continuous working pressure means the differential pressure
2. Motor should not work under the highest pressure and the maximum speed
3. The running time should not exceed 10% under intermittent working conditions
4. Recommending N68 anti-wear hydraulic oil, viscosity 37-73cSt, cleanliness ISO18/13.
5. The Maximum working temperature is 80 °
6. One hour running time under 40% of maximum working pressure is recommended before full capacity working.
7. The maximum allowable back pressure is 10MPa, but the recommended back pressure should not exceed 5MPa.a leaking pipes is needed when exceeding
A variety of connection types of flange; Rabbet:, output shaft and oil port.
上一篇: 買股票配资世界首選胜宇配资 山東瑞諾2013年國内齒輪泵企业三足鼎立局勢探析 下一篇: